Supplies Need:
Bulb No. 9004 Wattage 65/45 -- If using higher wattage, a wiring harness is
needed to keep from melting. Available at
SouthWestAutoworks
High pressure Halogen gas is sealed inside the
Halogen bulb. The bulb may break if the glass envelope is scratched or the bulb
is dropped. Hold the plastic base when handling the bulb. Never Touch the Glass
envelope.
- Disconnect the battery negative cable.
- Disconnect the electrical connector from the rear end of the bulb.
- Turn the bulb retaining ring counterclockwise until it is free from
the headlight reflector, then remove it.
- Remove the headlight bulb. Do not shake or rotate the bulb when
removing it.
- Insert the bulb into the headlight reflector with the flat
side of the plastic base facing upward.
- Install the bulb retaining ring and turn it clockwise until it stops.
- Push the electrical connector into the bulb plastic base until it
snaps and stops
|
|
