Warning: This procedure is very dangerous, you can very easily screw up your wiring. The key to doing this is taking your time and looking everything over twice before doing it.

Written by Daniel B Martin

If you want the clock display to remain at high intensity when the lights are on...

1) Remove the clock. This may be done with a small flat-blade screwdriver. Insert the screwdriver blade between the lower right hand corner of the plastic dashboard clock panel and the adjacent softer dash board. Slowly pry the panel up. Continue this at all four corners of the contoured panel until the metal snaps which anchor the panel are loose. Remove the panel by pulling outward and downward.

2) Note that the clock's electrical connector has four wires. Cut the wire which is red with a blue tracer.

3) Install the clock panel. It just snaps into place.