Error message

User warning: The following module is missing from the file system: file_entity. For information about how to fix this, see the documentation page. in _drupal_trigger_error_with_delayed_logging() (line 1128 of /home2/vqpower/public_html/v3/includes/

Change Mirror Blinker LED's


Here's Your basic 09 mirror. From here you take a small (tiny) flat head screw driver and take off the faceplate. There is just clips, no screws holding it in.

Once the plate is off it'll look like this:

From Here your going to pull the mirror off towards you. There is clips on here as well but if you pull from the bottom and move up u'll be fine.

Once the mirror is off. You'll see the wires attached to the mirrors (if your mirrors come heated) if not they'll be no wires here.

This is the screw you need to loosen. This is what's holding the blinker on.

This is the harness for the lights. Just plug this out and your blinker will be disconnected from the mirror.

Now this is the same idea as the headlights. I put my oven at 220 degree's and once it reached that temp. you SHUT IT OFF. Then you can put the blinker in there for about 3-10 minutes. (I kept checking mine)

Once the glue/silicon warms up you can separate the blinker with your hands.

once apart you can see the four leds. These are PLCC-4 Leds. They are hard to re-solder to the board because of the angle but obviously possible. lol